![](http://slrspeed.com/cdn/shop/products/Step1_20x16_crop_center.png?v=1502341774)
Ball Joint Stud Crossmember
Install the Inner Ball Joint Studs
How to install the inner ball joint studs from the bottom of the car. The torque setting is 90nm/65 ft/lbs.
![](http://slrspeed.com/cdn/shop/products/Step2_all_20x12_crop_center.png?v=1502341774)
Steering plates
Install the Steering Plates
Depending on your preferences, you have multiple adjustments here you can make on your steering plates. Mind the torque settings seen here.
E36 / E46 Angle Kit Installation
Check out Alberto's tutorial on installing the SLRspeed angle kit control arms and all.
E36 / E46 / Z4 Lower Control Arm Installation and Adjustment
Check out Santi's tutorial on installing and adjusting the SLRspeed rear lower control arms.
![](http://slrspeed.com/cdn/shop/files/control_arm_mod_20x11_crop_center.png?v=1722025471)
BUDGET ANGLE KIT
Step 1: Cutting the Control Arms
The main thing here is to keep the cuts as similar as possible on both sides of your car.
![](http://slrspeed.com/cdn/shop/files/control_arm_mod2_20x9_crop_center.png?v=1722025471)
BUDGET ANGLE KIT
Step 2: Measuring your cuts
Use the drawing here to get your arms to be the same size.
![](http://slrspeed.com/cdn/shop/files/20180806_142846_20x15_crop_center.jpg?v=1722025475)
BUDGET ANGLE KIT
Step 3: Fitting your extensions
Use the image here to reference where your cuts should be on your actual arms.
![](http://slrspeed.com/cdn/shop/files/20180806_143335_20x26_crop_center.jpg?v=1722025475)
BUDGET ANGLE KIT
Final measurements before welding
Double check your arms length is similar to what is shown here and then bevel your arm and weld together.