SLR Angle Kit Installation Instructions

Ball Joint Stud Crossmember

Install the Inner Ball Joint Studs

How to install the inner ball joint studs from the bottom of the car. The torque setting is 90nm/65 ft/lbs.

Steering plates

Install the Steering Plates

Depending on your preferences, you have multiple adjustments here you can make on your steering plates. Mind the torque settings seen here.

IDENTIFY STEERING PLATE

Torque Settings Per Steering Plate

To add on to the diagram above, some steering plates require different torque settings. Identify yours here and torque accordingly.

E36 / E46 Angle Kit Installation

Check out Alberto's tutorial on installing the SLRspeed angle kit control arms and all.

E36 / E46 / Z4 Lower Control Arm Installation and Adjustment

Check out Santi's tutorial on installing and adjusting the SLRspeed rear lower control arms.

BUDGET ANGLE KIT

Step 1: Cutting the Control Arms

The main thing here is to keep the cuts as similar as possible on both sides of your car.

BUDGET ANGLE KIT

Step 2: Measuring your cuts

Use the drawing here to get your arms to be the same size.

BUDGET ANGLE KIT

Step 3: Fitting your extensions

Use the image here to reference where your cuts should be on your actual arms.

BUDGET ANGLE KIT

Final measurements before welding

Double check your arms length is similar to what is shown here and then bevel your arm and weld together.