2020–2023 Audi RS7 C8 Sportback Front Bumper Splitter – Pre-Preg Dry Carbon Fiber

2020–2023 Audi RS7 C8 Sportback Front Bumper Splitter – Pre-Preg Dry Carbon Fiber

Sharpen the front end of your Audi RS7 C8 Sportback with this pre-preg dry carbon fiber front splitter. Precision-molded to the factory bumper, the extended lower profile increases visual depth for a wider, more planted, track-inspired stance without compromising the factory design language.

Build

• Material: Pre-preg dry carbon fiber in a 3K twill weave — the resin is pre-impregnated into the weave under controlled conditions before autoclave curing, giving exceptional strength, consistent weave, and a lighter finished component than standard wet carbon
• Manufacturing: Autoclave cured, precision 3D-moulded for accurate fitment
• Surface finish: Deep high-gloss UV-protected clear coat that showcases the 3K twill weave and protects it against fading and long-term surface degradation
• Configuration: Single-piece splitter for the lower front bumper

Design & Finish

• Aggressive stance: Extended lower profile adds front-end depth and visual width for a lower, more planted stance
• Carbon aesthetic: Refined 3K twill dry carbon weave and high-gloss clear coat deliver premium contrast against the factory paint
• Factory-style integration: Precision-molded to the contours of the factory RS7 front bumper for a clean, seamless fit

Fitment

• 2020–2023 Audi RS7 C8 Sportback (4-door)
• Fits the RS7 C8 factory front bumper only — not compatible with the standard A7 or S7, or aftermarket bumpers
• Not compatible with the earlier C7 generation RS7

Package Contents

• 1 × pre-preg dry carbon fiber front bumper splitter
• Automotive-grade adhesive tape

Installation

• No-drill, adhesive-mounted: Installs with the included automotive-grade adhesive tape — no drilling and no permanent modification to the factory bumper
• Surface prep: Thoroughly clean, degrease, and dry the front bumper before fitting to ensure maximum adhesion
• Alignment: Dry-fit and check the splitter sits centred and even across the bumper before final adhesion
• Professional installation recommended for correct positioning, panel alignment, and a clean finish

Before You Install

• Confirm your car is an RS7 C8 Sportback (2020–2023) before ordering — this will not fit the standard A7, S7, or the earlier C7 RS7
• Work in moderate temperatures and allow the adhesive to cure fully before washing the car
• Front splitters sit low and are exposed to kerbs, driveway ramps, and road debris — take care when parking nose-in

Products received may vary slightly from images due to manufacturing tolerances or supply chain variables.